You are not logged in.


Tuesday, January 24th 2017, 3:34am

QT 5.7 Error When Running Executable after Build

I FINALLY got my project to Build successfully but when I run it I get the following...

The procedure entry point _Z11UncompressPKhi could not be located in the dynamic link library C:\........\DBBrowser.exe.

DBBrowser.exe being, of course, the executable I built. I built it using MinGW 5.3.0 32-bit.

Suggestions? Thanks.



Tuesday, January 24th 2017, 5:01pm

I figured it out. Apparently I had copied the wrong DLLs to the executable directory. Must have been from the MSVC subdirectory rather than the MinGW subdirectory. In any event, it now works.